Des: DisplayPort pcb mount connectors 20 Pin DP Connector SMT Vertical through hole height 13 mm
Part No: DP-F06-13H
Specification:
Rating: 0.5A
Insertion force: 35N Max
Withdrawal force: 8N Min
Operating Life: 5,000Cycles
Packaging: Reel/Tray
- Home
- Products
- DisplayPort Connector
- 20 Pin DP Connector SMT Vertical T/H h=13mm
20 Pin DP Connector SMT Vertical T/H h=13mm
Related Products
Featured Content
FPC connectors: you’d better to know 2024
April 7, 2024
FPC connectors are a type of electrical connector used to establish a reliable and flexible connection between a flexible printed circuit board and other electronic components or devices. Many pitches are available, such as 0.3 mm, 0.5 mm, 1.00 mm, 1.25 mm, 2.54 mm, but the most common pitches are 0.500 mm, 1.00 mm, and 1.25 mm. A single FFC can have different pitches between different conductors on the same cable, however this is uncommon. There are 0.3mm pitch, 0.5mm and 1.0mm pitch zif/non-zif types FPC Connectors with different heights
Unveiling USB Type C 24 Pin Connector: Structure Breakdown & Key Technical Features
August 12, 2025
The USB Type C 24 Pin connector, as a widely used connection standard in modern electronic devices, holding significance for both users and developers . With the popularity of the USB Type C interface, the 24p vision has gradually become the mainstream choice due to its higher power management capability higher data transfer speed rates, and the convenience of reversible insertion. This article will discuss structure, technology feature to provide readers with a comprehensive understanding of this technology. USB Type C 24 Pin Connector Interface Pinout Design The core of USB Type C
The basic performance of electronic connector
January 2, 2025
The basic performance of electronic connector can be divided into three major categories: mechanical performance, electrical performance and environmental performance. 1. Mechanical properties In terms of connection function, plugging and unplugging force is an important mechanical property. Plug-in force is divided into insertion force and extraction force, and the requirements for the two are different. There are regulations on the maximum insertion force and the minimum separation force in relevant standards, which shows that the insertion force should be small, and if the separation force is too small, it will